Service HotlineIn the fastening connection parts and parts assembly of various equipment and tooling, if the screw and nut anti-loosening treatment is required, there is a contradiction between anti-loosening and tightening or tightening and loosening. For example, the resistance is large when tightening. , or the resistance is large when loosening, or the anti-loosening effect is not good, or the service life is short, and it will be scrapped after 2 to 3 times of use. In a word, all kinds of anti-loosening nuts have the above problems at present. Therefore, it is necessary to utilise a new type of anti-loosening nut with low resistance when tightening or loosening, but with better anti-loosening effect and long service life.
Traditional rivets have a single purpose and need to be used in combination in most occasions. The operation is complicated, labor-intensive, and the connection quality cannot be guaranteed. Therefore, there is a need for an integrated rivet.
The existing combination screws and accessories are individually processed and then handed over to the customer for assembly. This method is prone to assembly problems, and the combination screws and accessories need to be marked with identification marks, which increases the production cost.
With the mass production of large-scale equipment, standardization, and the concept of lean production, it has become more and more important to improve the efficiency of the assembly stage. Nowadays, when assembling small equipment, power tools and automatic bolt supply devices are basically popular, but only for M3 and smaller However, large equipment is often fastened with M8 or larger diameter bolts, and it is still in the process of combining manual and air tools. Among them, the pre-installation of the flat and spring washers on the bolts is completely manual operation. When the bolts need to be tightened in large quantities, the shortcomings of low efficiency are particularly obvious, and the flat and spring washers are easy to be scattered when manually assembled, and there are mixed installations of different specifications. Problems such as less installation and missing installation will affect the processing quality.
captive screw is a commonly used pressure riveting part. Usually the captive screws are directly riveted on the motherboard, so as to play the role of fixing the components, and there is a high requirement for the distance between the opening holes on the component. Once the distance between the through holes on the component and the If the distances between the riveting holes on the motherboard do not match, the components cannot be riveted on the motherboard, which will result in defective or scrapped products, thereby increasing production costs and reducing production efficiency.
We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: GB812, claw hand screw, flower tooth non-slip anti-loosening nut with pad, monitor stud and other products, we can provide you with suitable screws for you. Firmware Solutions.
