your location: 首页>>News>>Industry News

Service Hotline

+86760-8787 8587

Wholesale 304 stainless steel non-standard fine tooth hex screw hex bolt 5/8

author:[email protected] Click:6437end source: time:2022-12-05 10:03:42

Summary of information:We have more than ten years of experience in screw industry production, the main products are: T20 screws, camera tripod...

In the prior art, the hardware and the handle are generally assembled and connected by means of rivet riveting; in the process of assembling the hardware and the handle, the prior art adopts manual operation to realize the riveting and assembling process, which is time-consuming and labor-intensive. and low productivity.

However, this process scheme has high cost, low efficiency, and has certain difficulties in quality assurance. In order to ensure product production efficiency, reduce manufacturing costs and improve product quality, it must be considered that the blank forming is completed on a multi-station cold heading machine at one time.

Standard spring washer (GB/T93-1987) Light spring washer (GB/T859-1987) Heavy spring washer (GB/T7244-1987) Spring washer is also known as spring meson. Saddle spring washer (GB/T 7245-1987) Saddle spring washer (GB/T 860-1987) Wave spring washer (GB/T 7246-1987) Wave spring washer (GB/T 955-1987)

On the other hand, especially in the aerospace field, the requirements for the sealing effect of screws are extremely strict, and the traditional screws are directly tightened when screwed into the workpiece or equipment, and the sealing effect is determined by the tightness, but due to the machining error of the workpiece or equipment The direct butt seal between the seals is difficult to achieve.

For the detection of the shear force of the elastic cylindrical pin, the method and the tooling are marked, but the tooling is only a means to be used on the test bench, and the process of embedding the cylindrical pin into the tooling is a more difficult process. Generally, it is used to place the tooling on a plane, a vise, a simple V-shaped, and a simple U-shaped fixture. Originally, the elastic cylindrical pin was detected by hand or pliers to hold the cylindrical pin and align the pin with the outer cylinder of the tooling. Use a hammer to smash the shear holes, and adjust the concentricity of the inner and outer cylinders of the shear holes of the tooling from time to time. The limitations, dangers and difficulties of this assembly method are relatively large, often testing a set of cylindrical pins, which takes a lot of time and is difficult for lesbians to complete.

We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: hook and long triangle ring expansion bolts, claw screws, round head pan head bolts, audio nuts and other products, we can provide you with suitable tightening bolts. Firmware Solutions.

Non-standard fine teeth

Wholesale 304 Stainless Steel


The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].