During the daily use and operation of mechanical equipment, due to the influence of external load, internal stress, wear, corrosion and natural erosion, individual parts or the whole change size, shape, mechanical properties, etc., which reduces the production capacity of the equipment. The consumption of raw materials and power increases, the quality of products decreases, and even personal and equipment accidents are caused. Therefore, in order to make the machinery and equipment can often play the production efficiency and prolong the service life of the equipment, the equipment must be properly repaired and routinely maintained.
In the production process of Yueluo, according to the different gap guarantee schemes adopted in the mold design, different gap assembly adjustment methods are adopted accordingly. At present, the gasket method, light transmission method, measurement method, copper plating (zinc) method are often used Method, coating method, process allowance, locator positioning and other assembly adjustment methods. Generally speaking, for the working parts processed separately by the punch and the concave die, since the reasonable gap of the die has been formed theoretically, the assembly principle is to fix the working part that is not easy to adjust, and adjust the working part of the other working part. To change the position between the punch and the die to ensure a uniform gap, at this time, only the screws are pre-tightened, and the positioning pins are not fixed. Yueluo, however, many years of practical experience have made those skilled in the art notice that if they can pay attention to the positioning pins and use the positioning pins in a targeted manner in the mold design or manufacturing process, they can often produce miraculous results with half the effort. Therefore, it is very important to design a positioning pin for a specific mold, which is of great practical significance.
In the installation of the external electrical components of the high-voltage electrical box, generally, the whole aluminum alloy profile with a T-slot is laid on the shell of the high-voltage electrical box, and then the upper nut is placed in the T-slot, and the bottom of the square nut is provided with a spring , When installing the electrical components, align the mounting holes with the screw holes of the square nut, then screw and tighten the screws to achieve the installation of electrical components. The biggest defect in the above installation process is that the alignment of the mounting hole and the screw hole is not very convenient, and the spring at the bottom of the square nut is easy to be missing. Once the spring is missing or damaged, the square nut cannot be effectively positioned in the T-slot. It makes the alignment of the mounting hole and the screw hole more difficult. Third, the above-mentioned connection and fixing method itself is not particularly ideal.
Many parts on the car need to be rubberized, which can reduce noise, especially the parts related to shock absorption. Nuts are welded on many of these parts to facilitate the installation of other parts on them. The sheet metal is generally relatively thin, and most of them are only one or two millimeters. A through hole is punched, and then the nut is placed in the hole, and then around it. Spot welding is done so that it can be fixed. After spot welding, the periphery of the screw hole on the sheet metal will not be flat due to thermal deformation, which will affect the appearance.
A screw suitable for a variety of tools is a single-structure threaded part, including a screw body and a screw head. The outer surface of the screw body is processed with an external thread 1, and the outer side of the screw head is formed by six screw heads. Prismatic, the top surface of each edge of the outer hexagonal prism is a boss, between each boss is an end face groove 4, and the middle of each boss is provided with an end face hole 3; the inner side of the screw head is formed by six screw heads. The side surface 5 forms an inner hexagonal prism hole, and the bottom of the inner hexagonal prism hole is processed with a cross groove 10 .
We have many years of experience in the production and sales of screws, nuts, flat washers, etc. The main products are: German standard U-shaped screws, plastic head handle bolts, cage nuts, thumb screws and other products, we can provide you with suitable fasteners for you solution.