Customized GB109 flat head aluminum rivet aluminum solid rivet hand-beating percussion rivet pair lock rivet 5/8

We have more than ten years of experience in screw industry production, the main products are: national standard gaskets, contour screws, carbon steel nickel-plated one-piece caps, lifting ring bolts with rings, GB301976 screws, JA screws, anti-loose nylon nuts, five-pointed stars Shaped handle nut, knock-on-lock rivet knock-on flat-bottom isolation column rivet, half-tooth fine-tooth screw, furniture splint on-lock nut, ten years of professional production, through-hole hexagonal pressure riveting stud, round straight-through post, aluminum alloy bolts, etc. Fasteners, due to the different materials and specifications of the products, the prices are also different, if you need it, please contact us.

Online consultationMobile hotline
132 6870 6820
Product introduction

Screw Specifications

Screw head table

The existing open-type blind rivets are widely used, usually composed of an iron rivet shell and an iron or stainless steel mandrel. During the riveting process, the open-type rivets are often unstable and biased due to the unsteady breaking force of the mandrel. When the foam is riveted, the nail head is directly pulled into the foam layer to damage the product structure. And there may be safety hazards such as scratching the operator during the installation process due to the exposed nail core. At the same time, due to the expansion of the rivet shell hole, the nail head will be loose inside.

Customized GB109 Flat Head Aluminum Rivets

However, although the above-mentioned screw belt (2) can achieve the expected effect, it is also found in its actual implementation. Although this structure has multiple grooves on both sides of the main body for the driving and turning of the locking screw tool, However, the groove is only used for driving the screw belt drive, and since the screw will swing on the screw belt, it is impossible to stably align the screw on the screw belt with the point where the screw is to be set. , which leads to great inconvenience in operation and use, and also affects the efficiency of screw and screw installation, so that there is still room for improvement in the overall structural composition.

Aluminum solid rivets

hand percussion rivets

During assembly, the washer and the screw are two separate parts, and the washer needs to be put on the connection part of the screw, which increases the workload of people during assembly, and the washer is easy to slip off; and some screws are fixed with Although the washer can reduce the workload of people during assembly, the washer is fixed on the screw, and the original function of the washer is limited.

pair of lock rivets

Screws are very small screws used for indispensable industrial necessities in daily life, such as cameras, glasses, clocks, electronics, etc.; general screws for televisions, electrical products, musical instruments, furniture, etc.; large screws are used for engineering, construction, and bridges; Transportation equipment, airplanes, trams, automobiles, etc. use large and small screws together. At present, in the machine assembly production line, when the flat washers, spring washers and screws are matched during the screw assembly process, the flat washers, spring washers and screws are easy to fall into the product due to their small size, resulting in low screw matching efficiency. If there are flat washers, spring washers, screws, etc. that fall into the product and are not found in time and left inside the product, it may cause damage to the machine structure, and even cause casualties in serious cases.


The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].

Cooperation Case

Hot Recommend