your location: 首页>>Yueluo products>>Nut size

Production of diamond pattern aluminum column connection long nut FPV model rack double inner tooth mesh nut 3/8

We have more than ten years of production experience in the screw industry, the main products are: carbon steel color galvanized screws, galvanized shrapnel nuts, cup head socket head cap screws bolts and nuts, pull cap nuts, multi-toothed K-shaped hexagonal flower teeth, claw bolts ,Key flat key strip square key pin, flange machine screw bolts, alloy steel bolts, mixed screws Daquan, thickened hexagonal nuts, copper flat round head rivets, anti-loosening screws with pads, hollow copper studs, 12.9 lengthened Fasteners such as screws, due to the different materials and specifications of the products, the prices are also different, please contact us if necessary.

Online consultationMobile hotline
132 6870 6820
Product introduction

Screw Specifications

Screw head table

At present, the locking washer is widely used in the upper wheel side locking of passenger cars. During assembly, the locking washer is bent perpendicular to the thread of the axle pipe, so as to prevent the protrusion from passing through the gap between the two tooth profiles of the thread and ensure the locking The stop gasket is always in the groove of the shaft tube and cannot be rotated to achieve the purpose of locking. This method is relatively simple and is currently used more;

Production of diamond-patterned aluminum columns

Among them, the pneumatic riveting machine is more commonly used. The pneumatic riveting machine is also equipped with a clamp for assembling the rivet. The existing clamp usually uses two rotating clamps for fastening and assembly, but the rotation easily causes the two clamps to buckle. Misalignment, thus affecting the assembly of the rivet.

connecting long nut

FPV model rack

The retaining ring is a ring-shaped component fastened on the shaft and the inner hole. Its main function is to prevent other components installed on the shaft and the inner hole from sliding axially on the shaft. It is a fixed standard part.

Double Internal Threaded Nuts

Bolts refer specifically to screws with larger diameters and may also have no heads, such as stud bolts. In general, it is not called a stud bolt but a stud stud. The most common form of stud is threaded at both ends and a polished rod in the middle. The most typical use: anchor bolts, or places similar to anchor bolts, thicker connections, when ordinary bolts cannot be used.


The above content is uploaded by Yueluo or the Internet. If there is any copyright issue, please contact [email protected].

Cooperation Case

Hot Recommend